canon IR 8500

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • acsolutions
    Senior Tech

    500+ Posts
    • Jun 2010
    • 519

    #1

    canon IR 8500

    SKMBT_75011062413530.pdfleaving lines after long run. replaced t/s corona assembly also noticed paper lifting up under drum. this is a leagal document so the top portion is white out. Thanks
    Last edited by acsolutions; 06-24-2011, 11:19 PM.
  • teckat
    Field Supervisor

    Site Contributor
    10,000+ Posts
    • Jan 2010
    • 16083

    #2
    Try covering the Upper and Lower Pre-Transfer Guides with electrical tape

    arcing of the Transfer Guide Bias ???
    any error codes>>
    **Knowledge is time consuming, exhausting and costly for a trained Tech.**

    Comment

    • acsolutions
      Senior Tech

      500+ Posts
      • Jun 2010
      • 519

      #3
      I did the electrical tape on the lower guide due to a e-069 code that occurred several months ago. I did not see any codes that were resent, as far as the upper guide is it called upper registration guide, I did not see a pre-registration guide in the manual. Thanks for the responce

      Comment

      • mr.daus
        Technician
        • Apr 2011
        • 98

        #4
        fisrt chek the humidity paper
        then chek the registration cluth if the transfer sparation coronas was replaced
        chek cluth break,,, registration inlet plate from right deck cover are opened
        firdaus +(62)8195002007 firdaustrish@ymail.com

        Comment

        • acsolutions
          Senior Tech

          500+ Posts
          • Jun 2010
          • 519

          #5
          Yes, I replaced the reg. clutch. what am I looking for on the inlet guide? paper is good, running it through other machines. "registration inlet plate from right deck cover are opened" What am I looking for? have not checked the clutch break! thanks
          Last edited by acsolutions; 06-25-2011, 07:38 PM.

          Comment

          • teckat
            Field Supervisor

            Site Contributor
            10,000+ Posts
            • Jan 2010
            • 16083

            #6
            Originally posted by acsolutions
            Yes, I replaced the reg. clutch. what am I looking for on the inlet guide? paper, is good running it through other machines. "registration inlet plate from right deck cover are opened" What am I looking for? have not checked the clutch break! thanks


            ?????? is this image dark area only on legal size & is it in the same location all the time

            issue.JPG
            **Knowledge is time consuming, exhausting and costly for a trained Tech.**

            Comment

            • acsolutions
              Senior Tech

              500+ Posts
              • Jun 2010
              • 519

              #7
              yes, it seems to be in the same location. Doesn't seem to change positions! I am running it LTR only.

              Comment

              • mr.daus
                Technician
                • Apr 2011
                • 98

                #8
                paper sideways when entered into the registration,,may be caused feed roll before registration,,
                try LTRR and try LTR running, whats the difference???
                firdaus +(62)8195002007 firdaustrish@ymail.com

                Comment

                • KL568
                  _

                  250+ Posts
                  • Feb 2011
                  • 324

                  #9
                  Use to service this model ages ago, is there a pre-transfer ass'y? Tried pulling out & run a few copies.
                  The HVT's cable/plastic housing might be "burn"

                  Does paper jams occur when make copies in 2-sided mode for said 20 pages?
                  Transfer/Sep cable/plastic housing likewise have "burn" marks

                  Comment

                  Working...