If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The door SPEC of Ir6000 is OK, but feeder alignment leaves about 1.2 cm at the begging of the portrait paper so it lose it the end of the paper. It Ok with landscape.
The door SPEC of Ir6000 is OK, but feeder alignment leaves about 1.2 cm at the begging of the portrait paper so it lose it the end of the paper. It Ok with landscape.
Sorry, the terms portrait and landscape don't apply here, we have got the A4 and A4R, LTR and LTRR, etc.
I guess you need to adjust the ADJ-XY in the service mode, i.e. COPIER>ADJUST>ADJ-XY.
Comment