[Misc] canon ir clc 2620-c1 booting and display problem- I REPOSTED from wrong area- TECKAT

[teckat]

Original poster is below

goeff


Junior Member Join Date Sep 2011
Posts1
Rep Power0


canon ir clc 2620-c1 booting and display problem

my canon ir clc 2620-c1 was working ok untill this morning when it gives me this error E000732-0001.
i try to clear the error when i switch on and off the machine could not finish booting it will just stuck at
booting window . when tried to go to service mode to clear the error the display goes blank and i can not
access any thing because the display is not showing anything please help

[teckat]

Re: canon ir clc 2620-c1 booting and display problem- I REPOSTED from wrong area- TEC

U posted in a imageclass D880 discussion //
next time /switch your post to a iRC2620 heading , so all could see

READ THIS PDF ABOUT BOARD CLEANING/Re-Seating/& Measurement
Board Cleaning_TP07 094[1].pdf
this applies to all imageRunners, so disregard models listed on pdf- it does list the E732-0001 CODE
this procedure has helped many a tech and saved them time and money

when a single pin of each Sub PCB is not properly mated with the slot on the main controller. Therefore, when multiple boards have poor connections different error codes may occur.

try this first
power off printer/ unplug from wall/ follow below
Remove & Re-seat the ribbon cables between the Reader Controller and the Interface PCB
plug back in wall outlet/ /power up

or could be a defective Reader Controller PCB / or a defective DC Fuse PCB

[Rachid.Akli]

Re: canon ir clc 2620-c1 booting and display problem- I REPOSTED from wrong area- TEC

Just verify the connexions between the reader and the printer.