IRA 9070

[TEC DOG]

After clearing DCON and put the save values back in is everithing OK exept print position.It's not in the center any more.PG-10 test for axample
is on the one side of A4 almost to the edge of the paper.How can I moving print position?

Thanks

[charm5496]

Re: IRA 9070

After clearing DCON and put the save values back in is everithing OK exept print position.It's not in the center any more.PG-10 test for axample
is on the one side of A4 almost to the edge of the paper.How can I moving print position?

Thanks

sounds like you missed some door specs when you re-entered your data. Did you do a p-print before and after and make sure you have everything correct?

Are your trays reading letter size and not A4 by chance? how do the other paper sources look?

[KL568]

Re: IRA 9070

After clearing DCON and put the save values back in is everithing OK exept print position.It's not in the center any more.PG-10 test for axample
is on the one side of A4 almost to the edge of the paper.How can I moving print position?

Thanks

I might off the mark but after clear DC-Cont, have you go through the procedures of quality adjustment. i.e. ITB-POS?

[TEC DOG]

Re: IRA 9070

Yes guys,i make all of quality adjustments on the copier,again made rip calibration and yes,itb position made also.All trays are like before.A4 and A3.Everything from p-print is back in the machine.

[vigour]

Re: IRA 9070

copier>adj>feed-adj
change values until satisfied
each cassette has its own adjustment
duplex automatically re-adjusts when the single sided is changed