Photosensitive Drums life of CLC copiers

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • charm5496
    Service Manager

    Site Contributor
    1,000+ Posts
    • Apr 2008
    • 2387
    #16
    Re: Photosensitive Drums life of CLC copiers

    you are welcome. These machines can be head scratchers so dont be afraid to ask before doing something. If you can get your hands on a developer unit for the M it might be worth it, or just clean it all out and add new developer to it.
    Accidents don't just happen. They must be carelessly planned.

      Comment

      • teckat
        Field Supervisor

        Site Contributor
        10,000+ Posts
        • Jan 2010
        • 16083
        #17
        Re: Photosensitive Drums life of CLC copiers

        u should only do the STIR & INIT when replacing(starter)

        i always did a FULL all Starter change when needed on Volume use

        and replaced all stater on a Drum change-
        this will prevent a lot of E020 errors/

        tech tip on erroneous E020/Dirty grid plate->>>>> in back of printer / facing the back > remove back cover & in upper right side corner> on the FM2 Exhaust fan >remove that fan ozone FILTER & throw in garbage> do not replace u


        and make sure to replace or clean the filter of the FM3 Primary charging assembly fan/ rear upper left corner
        **Knowledge is time consuming, exhausting and costly for a trained Tech.**

          Comment

          Previous 1 2 template Next
          Working...