[Error Code] AnyOne Please Help me....

[madhusel]

i am facing error code e00064-0000 IN IR 3300 MACHINE, I HAVE REPLACED THE DRUM, AND ALSO CHECKED THE HVT PCB, STILL THE PROBLEM OCCUR, PLEASE ANY ONE GUIDE TO SOLVE THIS ISSUE THANKS IN ADVANCE....

THANKS AND REGARDS
MADHUSEL

[zoraldinho]

Re: AnyOne Please Help me....

E064-0000


The presence of a high-voltage error is communicated by the composite
power supply PCB. (The output for primary charging, developing, or transfer
has deviated from a specific level of voltage.)

Main cause The contact has poor connection. The wiring is faulty. The composite power
supply PCB is faulty. The DC controller PCB is faulty.

Action

1. Contact

Is any of the contacts of the primary charging roller, developing assembly,
or transfer charging roller soiled? Or, is there poor contact?
YES: Clean the contact, and set it once again.

2. Wiring

Is the wiring between the contacts for the following normal: DC controller
PCB (J301), composite power supply PCB (J136), primary charging roller,
developing assembly, transfer charging roller?
a. DC controller PCB (J301) <-> composite power supply PCB (J136)
b. composite power supply PCB (J130-7) <-> primary charging roller contact
c. composite power supply PCB (J130-1) <-> developing assembly contact
d. composite power supply PCB (FT133) <-> transfer roller contact
NO: Correct the connection.

3. Composite power supply PCB, DC controller PCB

Try replacing the composite power supply PCB. Is the problem corrected?
YES: Yes.
NO: Replace the DC controller PCB.

[dhanesh]

Re: AnyOne Please Help me....

did u reset error and ram clear?

[mramlawi]

Re: AnyOne Please Help me....

once Happen with me at the same machine and it was weakens on Electricity so check the power of the Socket try to plug it directly without any extanstions.

regards