canon IR2318 does not boot

[montana]

..i have canon ir2318..when i power on the copier start to initialize and the loading bar reaches
to the middle then stop there..anybody seen this?and what is the solution?
thanks.....

[doktor]

Re: canon IR2318 does not boot

Can you put the machine in download mode?I will try first with new firmware.

[Oze]

Re: canon IR2318 does not boot

The manual tells you what the boot up sequence of the progress bar means....it may be HDD or it MAY be SDRAM.

[DAG COPIERS & COMPUTERS]

Re: canon IR2318 does not boot

This machine does not have a HDD to store its systems program unlike the other models. I would instead suggest that you check the connections to the pcbs to ensure proper contacts, try also to remove and reseat the memory modules, ensuring that the seat and make proper contacts with slot. u may then try the downloads if the above fails.

[mramlawi]

Re: canon IR2318 does not boot

Hello

as friend said try to remove the Sdram and clean it then put it back

[teckat]

Re: canon IR2318 does not boot

..i have canon ir2318..when i power on the copier start to initialize and the loading bar reaches
to the middle then stop there..anybody seen this?and what is the solution?
thanks.....

Image Processor PCB
unplug LAN pcb (NETWORK I/F PCB)/ power up/ see what shows