ir3300 jaming

[universaltvm]

i have a canon iR3300 and it always jammed when we do 2 sided printing. it jammed between the the drum unit and the transfer unit where the paper is folded.

[linuxxpwin]

Re: ir3300 jaming

i have a canon iR3300 and it always jammed when we do 2 sided printing. it jammed between the the drum unit and the transfer unit where the paper is folded.

Check duplex motor and gear on motor.

[teckat]

Re: ir3300 jaming

i have a canon iR3300 and it always jammed when we do 2 sided printing. it jammed between the the drum unit and the transfer unit where the paper is folded.

check for broken gear on the Horizontal Registration Motor.


Gear- 14T / 56T-FS7-0750-000
M3 Motor - FK2-0144-000

check contact pin at intermediate connector J3040-2. This is the signal line for M3, the horizontal registration motor. Reform the contact pin if bent >to the proper position.

E051-0000- At start-up, home position is not detected when the horizontal registration assembly is moved 100 mm in the direction of home position.

Main Cause- The horizontal home position sensor is faulty. The horizontal registration motor is faulty. The DC controller PCB is faulty.

1. Connector
Are the connectors of the horizontal registration home position sensor and the horizontal registration motor connected?
a. DC controller PCB (J304) <-> relay connector <-> horizontal registration home position sensor
b. DC controller PCB (J304) <-> relay connector <-> horizontal registration motor
NO: Connect the connectors.

2. Sensor lever (damage and interference),
Sensor
Is abnormal noise heard from the horizontal registration assembly in keeping with the motor rotation?
YES:
a. The horizontal registration assembly is out of place because of damage to the sensor lever. Replace the sensor lever.
b. The horizontal registration assembly malfunctions because of the presence of foreign matter. Remove the foreign matter.
c. The sensor is faulty and cannot detect home position. Replace the sensor.

3. Horizontal registration motor, DC controller PCB
Is the horizontal registration motor control signal generated by the DC controller PCB?
J304-1/2: 24 V, J304-3/4/5/6: motor excitation signal
YES: The horizontal registration motor is faulty.
Replace the motor.
NO: Replace the DC controller PCB.

[copicatt]

Had one of these where the sep unit contact was broken off. It would jam folded at the drum only on 2 sided. Might want to check it....

[universaltvm]

Re: ir3300 jaming

copies no sound is heard,but wen i make above 3 or more copies 2sided the problem arises

[teckat]

Re: ir3300 jaming

copies no sound is heard,but wen i make above 3 or more copies 2sided the problem arises

Horizontal registration

Bright idea.jpg