CLC4040:Image vertical size reduction and trapeze effect on the trailing edge

[Rachid.Akli]

Hello every body,

We have a CLC4040 equiped with an H1 Fiery. It has two issues that might be related:

1- The image size is reduced in the vertical direction with about 2mm on A3+, heavy media.

2- The image presents a trapeze effect at the trailing edge with the same media.

The above mentioned issues are not observed on A3, plane media.


The machine DC-CON = 61.02
MN-CON = 87.5

Counter = 360 000 with a large amount of A3+, Heavy media.


Rachid.

[teckat]

Re: CLC4040:Image vertical size reduction and trapeze effect on the trailing edge

Hello every body,

We have a CLC4040 equiped with an H1 Fiery. It has two issues that might be related:

1- The image size is reduced in the vertical direction with about 2mm on A3+, heavy media.

2- The image presents a trapeze effect at the trailing edge with the same media.

The above mentioned issues are not observed on A3, plane media.


The machine DC-CON = 61.02
MN-CON = 87.5

Counter = 360 000 with a large amount of A3+, Heavy media.


Rachid.

A3+ 329mm (12.95") x 483mm (19")
is that glossy photo paper ????

what is weight of paper ??
are u running this HEAVY paper from Manual Feed ???

Adjustment of Paper Width Standard Value of Manual Feed Tray
COPIER > ADJUST > CST-ADJ > MF-A4R
COPIER > ADJUST > CST-ADJ > MF-A6R
COPIER > ADJUST > CST-ADJ > MF-A4
Adjusting the paper width standard value of the manual feed tray.

remove MF &
Check the bypass rollers, guides and registration roller assembly -remove and clean. Checked if the Registration Door Specifications are correct.
Check the Upper Registration Guide / they warp

guide.JPG





PAPER.JPG