Staple finisher ir5880c

[Apach]

Hello

How to adjust exact staple position on finisher R1 ?
Staple.pdf

Tnx

[teckat]

Re: Staple finisher ir5880c

[ATTACH]15640[/ATTACH]

wrong pdf posted/
? was on stapler unit/ staple adjustment

[vigour]

Re: Staple finisher ir5880c

Doc2.pdf

[Apach]

Re: Staple finisher ir5880c

Thanks a lot.

[Apach]

Re: Staple finisher ir5880c

I tried to adjust but the upper corner of the end of the machine can not be adjusted. I guess the problem is mechanical nature, and that I have a position sensor to adjust. If someone has a diagram to post. Tnx

Staple.jpg

[teckat]

Re: Staple finisher ir5880c

I tried to adjust but the upper corner of the end of the machine can not be adjusted. I guess the problem is mechanical nature, and that I have a position sensor to adjust. If someone has a diagram to post. Tnx

[ATTACH=CONFIG]15647[/ATTACH]

I believe u need to adjust the swing guide pressure position first>
>then staple position // will check on it

Finisher R1 / Saddle Finisher R2
An alternate procedure uses a spring gauge to adjust the down pressure of the swing guide.
Alternate Procedure:
Prepare a 20lb letter size sheet of paper with a punch in the short edge of the paper. This will be with for a spring gauge.
a) Turn off the imageRUNNER.
b) Set finisher controller pcb bit 1,2,5,7 & 8 to 'on'.
c) Turn on the imageRUNNER.
d) Press switch 103 once to raise the swing guide.
e) Place letter paper in the swing guide path in the landscape direction.
f) Press switch 103 once to lower the swing guide.
g) To apply more pressure press switch 102 (each press = .2mm), to lower pressure press switch 101 (each press = .2mm).
h) Adjust the pressure so that the paper begins to pull out at 200 to 300 grams of pressure.
i) Press switch 103 once to lock in the adjustment. Turn off all dip switches and reboot the machine.

If a spring gauge is not available, adjust the down position so that the sheet of paper has a slight drag when pulled away from the swing guide.

IMG_6267_3.jpg

[vigour]

Re: Staple finisher ir5880c

I have only had this issue on 8500/7105.The stapler rack on those units is adjustable, so you can change the angle slightly. Not sure about your finisher.The stapler position is also adjustable.Anyhow, changing the stapler shift motor is supposed to fix that problem.