canon laserclass 710 error - no code

[teckat]

Re: canon laserclass 710 error - no code

BITS.JPG

Error codes
a) Service error code output
When service data #1 SSSW SW01 bit 0 is set to “1” then service error codes are printed on the activity management reports, reception result reports and error transmission reports when communication is terminated due to an error.

[KenB]

Re: canon laserclass 710 error - no code

You do understand bit 1 is the last bit in the string, not the first one?

Last I remember, Bit 1 is the second last, the last one is actually Bit 0.

[Hopper]

Re: canon laserclass 710 error - no code

Yes, I changed the last one to 1, no code display.
The machine boot up normally, display normal, after a minute it starts idle beeps and the red error light blinks, display stay normal.

With the old 7000's it was either the fuser or the power supply. The power supply was where the power cord plugged in. Since you have done the fuser I'd try the power supply. The power supply directly runs the fuser. Do you have any parts machines? We may.

Hopper

[gideon]

Re: canon laserclass 710 error - no code

Yes, I changed the last one to 1, no code display.
The machine boot up normally, display normal, after a minute it starts idle beeps and the red error light blinks, display stay normal.

[Hopper]

Re: canon laserclass 710 error - no code

I have this machine error light blinks no code number. set sw01 to 1 nothing, replace fuser just in case, it didn't help, any idea?
I have the manual for the 7130 and try to find the one for the 710.
Thanks.

You do understand bit 1 is the last bit in the string, not the first one?

[gideon]

I have this machine error light blinks no code number. set sw01 to 1 nothing, replace fuser just in case, it didn't help, any idea?
I have the manual for the 7130 and try to find the one for the 710.
Thanks.