[Misc] falla en la maquina ipc7000vp

[luisalberto9999]

derrame de revelado amarillo , ya se cambio la unidad de revelado amarillo , ya se ejecuto el boletin TP11-145a-S , el problema aun persiste , gracias por el apoyo .

[teckat]

Re: falla en la maquina ipc7000vp

derrame de revelado amarillo , ya se cambio la unidad de revelado amarillo , ya se ejecuto el boletin TP11-145a-S , el problema aun persiste , gracias por el apoyo .

translation

revealed yellow spill, already change the yellow developing unit, and was executed the bulletin TP11-145A-S, the problem still persists, thanks for the support.

Increasing the Frequency of the Knocking Operation from a Default Setting of "1" to "3" may help resolve the problem.

Note: Adjustment can be changed in Service Mode Setting:
Level 1>
Copier>Option>Body>VIB-Y-On. If necessary, the adjustment can be changed on any one of the Color Stations.



what is your enviorment at printer location ?

did you follow the entire tech pub instructions ????

[Joseph2011]

Re: falla en la maquina ipc7000vp

Adicional a este tema tengo el mismo problema me podrian ayudar por favor en mi maquina se cae los 4 reveladores en forma aleatoria

saludos

translation








increasing the frequency of the knocking operation from a default setting of "1" to "3" may help resolve the problem.

note: Adjustment can be changed in service mode setting:
Level 1>
copier>option>body>vib-y-on. If necessary, the adjustment can be changed on any one of the color stations.


what is your enviorment at printer location ?

Did you follow the entire tech pub instructions ????

[teckat]

Re: falla en la maquina ipc7000vp

Additional to this issue I have the same problem could you please help me in my machine falls in the 4 randomly developers

regards

did u read this---

did u leer este

haga clic en el enlace de abajo



Quality Assurance Kits C7000--TP12-2.pdf


he actualizado el firmware del sistema

[its_just_a_copier]

Re: falla en la maquina ipc7000vp

I take support calls for IPC7000s nationwide, and all I hear of say the same thing. Replace the Developer Unit and restart is basically the only thing you can do.

Check your Temperature (COPIER>DISPLAY>ANALOG), if the value is too high (<40 degrees) then correct the ventilation problem or environment. The heat can transfer from the primary fuser to the Yellow Developing station, causing clumping & dumping.

Buena Suerte!