[Misc] iRC 3220 Printing issue.

[Smartmind]

Hello everybody!
When I do photo prints image comes out with wrinkles, not on Paper but on the image, i tried fix it, i checked the IT Beld, does someone knows what is causing this issue?
Thanks in advance.

[mjarbar]

If you change the paper type does the problem repeat itself?

When you print photo quality the colours are laid down 'thicker' to up the quality. If the paper type isn't changed to compensate you can get cq problems.

[Juxta5]

Re: iRC 3220 Printing issue.

It is difficult to be certain what you mean by "wrinkles" without being able to see a scan of an image.

If your paper is is exiting nice and flat than I would say you're having problems with either color-registration which is a fairly common and an easy fix if you are a repair person... essentially the rollers & the underside of the transfer belt could be filthy causing mis-registration iR3200 TP03-1.pdf;
or could be having trouble with uneven density which applies the toner with a thick, thin, thick, thin effect -- in which case attempt the following in user mode: adjust/clean>auto gradation correction>full correction. Be sure your glass is clean before hand and be sure to use the same paper as your project.

If these fail.. try uploading a scan of your mis-print.

Cheers

[Smartmind]

Re: iRC 3220 Printing issue.

It is difficult to be certain what you mean by "wrinkles" without being able to see a scan of an image.

If your paper is is exiting nice and flat than I would say you're having problems with either color-registration which is a fairly common and an easy fix if you are a repair person... essentially the rollers & the underside of the transfer belt could be filthy causing mis-registration [ATTACH]16705[/ATTACH];
or could be having trouble with uneven density which applies the toner with a thick, thin, thick, thin effect -- in which case attempt the following in user mode: adjust/clean>auto gradation correction>full correction. Be sure your glass is clean before hand and be sure to use the same paper as your project.

If these fail.. try uploading a scan of your mis-print.

Cheers

Thanks by replying!
I have had changed the photo Paper type and size (11" x17") by (12" x18"), but when i do change it, some time it does work fine till 10 or 12 prints then the issue shows up.
i'm attachtching a sample.
thanks again.Sample.JPG

[teckat]

Re: iRC 3220 Printing issue.

place a sheet of OHP Transparency Film on glass>
place the picture (photo) on top of Transparency/ close cover>

make a copy > report back

[teckat]

Re: iRC 3220 Printing issue.

Take the fixing unit out & have a look at the fixing & pressure rollers, (or just open the exit doors & look) the plastic coating starts to wrinkle & this creates the exact faulty image you have. If this is the case you will need to replace the fixing unit.

good point
threw me off when poster said not on paper -but on image

forgot about those crappy plastic coatings on fuser rollers leaving impressions on full color images> especially on photo paper

[Smartmind]

Re: iRC 3220 Printing issue.

Thanks everybody!
Suggestions always are welcomes!
I think now it is going to work for a while, there was an inappropiate rollers presion, already calibrated now looks ok
Thanks again!