Canon CLC 1110 JAM Code 0052

[berni911]

Hi,

I have following problem. After cleaning and changing the oil felt in the fixing unit i get always a paper jam with error code 0052.
I have cleaned PS71 and done COPIER -> FUNCTION -> SNS-ADJ -> CLN-OFST.
But the jam still resists with the same code. The connectors of the transfer frame are clean.
When I clean the jam the paper lies between the transfer drum and the photo drum without attraction...

The maschine has 42000 clicks.

Thanks a lot

[teckat]

Re: Canon CLC 1110 JAM Code 0052

Hi,

I have following problem. After cleaning and changing the oil felt in the fixing unit i get always a paper jam with error code 0052.
I have cleaned PS71 and done COPIER -> FUNCTION -> SNS-ADJ -> CLN-OFST.
But the jam still resists with the same code. The connectors of the transfer frame are clean.
When I clean the jam the paper lies between the transfer drum and the photo drum without attraction...

The maschine has 42000 clicks.

Thanks a lot

when paper loses attraction -it pitches up & PS71 jam code will appear /
replace that sensor unit------------

Check that the mounting plate for the Attraction Blade Assembly is positioned correctly.
have u run an paper attraction check ?? to see position on TD
ADJUST>FEED-ADJ>ATTCHK

Make sure that Separation claw is not dropping to early (lifting up paper edge before development )

why it happens when u always change oil felt ?? /

make sure there is no oil on T/SHEET----have seen this many times