IR3300 won't boot up

[pengtech]

hi, i have a ir3300 hang up at the startup screen. After it finished the startup bar. It hang up with the message wait. I have changed the HDD, cleaned the boot ROM and SDRM, re-sit connectors. Is there other suggestions to solve this problem. Many thanks.

[charm5496]

Re: IR3300 won't boot up

replace the RAM, main controller or boot rom. These are the only items operating during the initial machine start up and if cleaning did not help then it is time to replace.

[teckat]

Re: IR3300 won't boot up

hi, i have a ir3300 hang up at the startup screen. After it finished the startup bar. It hang up with the message wait. I have changed the HDD, cleaned the boot ROM and SDRM, re-sit connectors. Is there other suggestions to solve this problem. Many thanks.

could be bad Memory

do u have a Fiery connected ??
or a paper Deck connected ?

or
disconnect Fax board if installed/power off-on

[pengtech]

Re: IR3300 won't boot up

Thanks Charm5496. I will to change tomorrow. Hope it works. Thanks again....

[pengtech]

Re: IR3300 won't boot up

No. Teckat.

[Canon.Tech]

Re: IR3300 won't boot up

If you wait, are there any error messages?

[pengtech]

Re: IR3300 won't boot up

I have changed the main controller, boot rom and ram this morning, but the same problem occured. At last the problem is solved, the fax unit is faulty. Many thanks to you guys out there and especially to TECKAT....

[teckat]

Re: IR3300 won't boot up

I have changed the main controller, boot rom and ram this morning, but the same problem occured. At last the problem is solved, the fax unit is faulty. Many thanks to you guys out there and especially to TECKAT....

COLOR HAND.jpgwe all support each other here

[Simons]

Re: IR3300 won't boot up

I was wondering If I would ever see one of those fax units die or cause trouble. What a way to go eh? Thanks for the post OP!