Canon IR C3220 C1 fiery

[skibum]

I have 1 that I picked up preowned for a customer that will print a single print job fine, but if there are 2 back to back jobs then the machine cycles and the data light stays on infintely. Then you can sometimes go into the RIP and release the document to print. It will fail to print multi back to back jobs consistently where you need to go into the RIP. The copier system software will be upgraded from 30ish to 90.03, then I will reinstall new system software to the fiery (C1). I only have the C1 2.0 system software, will that be a problem? Has anyone had any of these printing issues, memory also could be the issue??

Thanks in advance.

[teckat]

Re: Canon IR C3220 C1 fiery

I have 1 that I picked up preowned for a customer that will print a single print job fine, but if there are 2 back to back jobs then the machine cycles and the data light stays on infintely. Then you can sometimes go into the RIP and release the document to print. It will fail to print multi back to back jobs consistently where you need to go into the RIP. The copier system software will be upgraded from 30ish to 90.03, then I will reinstall new system software to the fiery (C1). I only have the C1 2.0 system software, will that be a problem? Has anyone had any of these printing issues, memory also could be the issue??

Thanks in advance.

What print drivers are u using


Memory is probably the issue/
imagePASS-C1 has a maximum memory configuration of 256MB of RAM. The C1 ships standard with one (1) 128MB DIMM installed in DIMM1. To upgrade, install another 128MB DIMM in the outer slot (DIMM2).

what type of documents from what Apps
C1 2.0 is fine

ver.30 to old