Canon ir c3200 fiery help

[century]

Hello everyone, I have a problem with the ImagePass C1. If you could point out what am I missing, I am really appreciated.

I have a Canon IR C3200 and now I just bought a fiery ImagePass C1.
some one told me that I have to replace a board FG3-2729 to FG3-2730 to make it work. Because right now I have FG3-2729 and I could not setup the IP in Fiery.

Thanks

[Van Steal]

Make sure you fit the interface pcb (should come with fiery)
then change img-cont under service mode (option)to 3 see below
Good Luck
<INT-FACE>

Used to set conditions when copier is connected to external controller.

IMG-CONT

Used to set connection to PS print server unit.

Setting 0: Normal mode (no PS print server unit)

1: Not used
2: Not used
3: PS print server unit
4: Not used
5: Not used

[charm5496]

open IF board

I have one of those boards if you are still in need of one. FG3-2730-000

[lkrsardis]

c1

Here is the config. guide.

[lkrsardis]

c1

Sorry, can't seem to get the attachment to stick.

[century]

To Van Steal, Yes I think that's the problem. The IF PCB does'nt come with the fiery. Thanks

To charm5496, Can you email me how much you want for that IF PCB. Thanks

To lkrsardis, Can you email that config guide. I would appreciated.

My email is mr2lp@yahoo.com

[century]

Thanks lkrsardis, I just got the guide.