Hi folks,
Here in Tanzania I am on my own with this device. Toner and drums are renewed, H1 is in the network, it scans, but greets me with this print:
1.jpg
To better understand the coordination I put on an InDesign A4 page in the middle vertical a thin black, cyan, magenta and yellow line with no gaps. Then I copied and rotated that line by 90deg. In the scan I present here I drew a vertical line with a blue pen to show the vertical centre where all line where supposed to be.
2.jpg
This scan confirms what is also notable from scan1: the respective colours deviate to the right horizontally. Vertically all seems correct.
How can I fix that please?
I compared all values set in service mode 2 [*,2,8,*] with the ones on the print-out I got when I bought the machine = all correct.
Here in Tanzania I am on my own with this device. Toner and drums are renewed, H1 is in the network, it scans, but greets me with this print:
1.jpg
To better understand the coordination I put on an InDesign A4 page in the middle vertical a thin black, cyan, magenta and yellow line with no gaps. Then I copied and rotated that line by 90deg. In the scan I present here I drew a vertical line with a blue pen to show the vertical centre where all line where supposed to be.
2.jpg
This scan confirms what is also notable from scan1: the respective colours deviate to the right horizontally. Vertically all seems correct.
How can I fix that please?
I compared all values set in service mode 2 [*,2,8,*] with the ones on the print-out I got when I bought the machine = all correct.
Comment