Canon ir5075 E0061

[hamdyyassin]

I have an error E061-0001 in my copier ir5075 .I cleaned potential control sensor and the primary corona unit but the same error happend after warming up without copying any paper.
When i turn off po-cnt it prints about 50 papers and give E061-0002 then i clear the error, it workes again and prints about 50 papers , the same error e061-0002.
Thanks for help.

[zoraldinho]

Re: Canon ir5075 E0061

copier counter (drum life)??

Inspect laser assy (shutter).


Potential sensor PCB faulty?

[Fer]

Re: Canon ir5075 E0061

How is the primary corrona? How is Tp3 with po-cnt disabled?

[charm5496]

Re: Canon ir5075 E0061

sounds like it is time for a potential control sensor and board or a new laser unit. The laser could be getting weak causing the issue

[Cycle Clutch]

Re: Canon ir5075 E0061

Check connectors on back frame of copier behind slide out transfer/fixing assy. units for torn paper. Check both male and female connectors.

[pawankchopda]

Re: Canon ir5075 E0061

opne laser unit aftr clen mirrer motar /potential control sensor allows on