Hi everyone im new in this forum and after read some post i came now with my own problem with a copier canon ir5075
When i make a copy the copier lengthens the plane of the X so i have to reduce by system the plane of X to 85 or 88%, the same problem appears when i try to print from computer.
Thinking than the problem is on system software i run FDD and reinstall the firmware but the problem does not resolve is this a mechanical problem? or maybe is an drum engine problem?
I'll appreciate any comment to try to solve this problem
When i make a copy the copier lengthens the plane of the X so i have to reduce by system the plane of X to 85 or 88%, the same problem appears when i try to print from computer.
Thinking than the problem is on system software i run FDD and reinstall the firmware but the problem does not resolve is this a mechanical problem? or maybe is an drum engine problem?
I'll appreciate any comment to try to solve this problem