New canon IRAC2225

[Canonman10]

Hi Guys,
I installed a Canon IRAC2225 recently and I cant turn the "sleep mode" off, the lowest adjustment is 5 minutes, but no constant power on.
Also, I cannot enter ID mode setup, can anyone help? (I hope this just wasnt because of this was my last install on a Friday!)
Doug

[teckat]

Re: New canon IRAC2225

Hi Guys,
I installed a Canon IRAC2225 recently and I cant turn the "sleep mode" off, the lowest adjustment is 5 minutes, but no constant power on.
Also, I cannot enter ID mode setup, can anyone help? (I hope this just wasnt because of this was my last install on a Friday!)
Doug

------------set below offin service mode
Service Mode Classic Level 1- follow the steps bellow:

1) Select Settings/Registration

2) Hit 2 & 8 at the same time

3) Select Settings/Registration

then--
COPIER > OPTION > USER>SLEEP
Setting of auto sleep function-To set ON/OFF of auto sleep function
0: OFF, 1: ON

default is set ON-
noteON)Transfer time to sleep mode is set in the user mode (Preferences>Timer/Energy Settings> Auto Sleep Time).

[teckat]

Re: New canon IRAC2225

Hi Guys,
I installed a Canon IRAC2225 recently and I cant turn the "sleep mode" off, the lowest adjustment is 5 minutes, but no constant power on.
Also, I cannot enter ID mode setup, can anyone help? (I hope this just wasnt because of this was my last install on a Friday!)
Doug

--------------------------------------------------
Default System Manager ID and Pin on the new imageRUNNER ADVANCE
Default System Manager ID is 7654321.
Default System PIN is 7654321.

This ID and Pin is also needed for the Remote UI=

To Change the System Manager ID and Pin on the Control Panel:
1. Press Settings/Registration.
2. If Management Settings is greyed out, then Login as System Manager.
3. Press Log In, Enter in System Manager ID and Pin. Press Log In.

--------------------------------
To disable the system manager ID, both fields listed under Settings / Registration > Management Settings > User Management for System Manager ID and System PIN should have all '0's entered in them. This will disable the login box under the Settings / Registration screen.