[Error Code] In canon 6570 when machine is switch ON error E000004-0106 and sometimes E000004-010

[Guest]

In canon 6570 when machine is switch ON error E000004-0106 and sometimes E000004-010 appears , what is the reason? pleeeeeeeeeazze bro

[SCREWTAPE]

Re: In canon 6570 when machine is switch ON error E000004-0106 and sometimes E000004-

In canon 6570 when machine is switch ON error E000004-0106 and sometimes E000004-010 appears , what is the reason? pleeeeeeeeeazze bro

Check the fixing and fixing feeder ass'y connectors for bent pins.

Also you can clear the code in service mode.

Additional functions, 2 & 8, Additional functions

Service mode/copier/function/clear/err/ok

Reboot.

[teckat]

Re: In canon 6570 when machine is switch ON error E000004-0106 and sometimes E000004-

E004 =The IH power supply is faulty/the IH control mechanism is faulty.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)

sub codes:

0101 There is a mismatch between the input voltage
and the IH power supply ID. Replace the fixing heater power
supply with one designed for the country of installation (voltage).

0102 The IH current is faulty. (current leakage) - Check the connector
for any fault in connection.
- Replace the fixing heater power supply.
- Replace the DC controller PCB.
0103 The IH current is faulty. (no current)
0104 There is an IH over-current.
0105 The IH input voltage is too high.
0106 The IH input voltage is too low.
0201 At power-on (or, when IH is at reset), the IH
control mechanism is not in an initial state.
0202 At IH start-up, the IH control enable flag is not set
within 1 sec after the start flag is set.
0203 With IH at rest, the IH control flag is not released.
0204 The 12-V power supply (IH relay) is identified as
being off.
0205 At IH start-up, the PWM_ON data is faulty ('0' or
'FFFF').
- Replace the DC controller PCB.