help canon irc3380 is error e003-001
-
-
Re: irc3380
==================
E003 sub code 0001---------This error code can be cleared in Service Mode/ but I would check below
If the fixing unit is not turning; fixing end thermistors, TH2 and TH3, will not heat up properly causing an E003 0001 to occur. This can be caused by the one way gear in the fixing drive assembly slipping, (ie: the fixing drive motor is turning but the fixing unit is not being driven). (See pic below for location and part number).
or check---------
this error code may be caused by the right door lower hinges break (crack). The right door will tilt slightly and not allow the actuator to activate SW3 properly, hence causing E003 error code.
Clear the error code in service mode, and cheat SW3 and power cycle the printer to verify if the position of the right door is the cause for this error code. Upon successful verification, the replacement of either right door hinges would be necessary to resolve the error code.
Item 50: FC7-7002-000 Upper Cap
Item 47: FC7-7000-000 Upper Cap
Item 48: FC7-7001-000 Lower Cap
Item 70: FC7-7003-000 Lower Cap
+++++
?????????? how old is your fixing film unit
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
Re: irc3380
Before replacing such things as, the entire Fixing unit, the DC Driver PCB, AC Driver PCB, and DCON; check SW3 and it's right door actuator.
In some cases SW3 has been found to cause E003-------------codes
SW3 is the Fixing unit's AC interlock switch. Sometimes the right door actuator will be bent and not fully press SW3 when the right door is closed. SW3 is a button switch located right above some of the Fixing unit's rear frame connections.
SW3 has been found to show signs of wear and have carbon build up inside it. If the right door actuator is straight and making good contact , inspect SW3 and it's AC connections. If any flaws are found after inspecting SW3, replace it.
SW3's part number is, FM2-9427-000. The image below is for reference purposes only, it points out SW3 and it's right door actuator.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
Comment