I was doing an "Adjustment of the Speed of Swing guide" on a S.Finisher V2 on an iR7105.
The result is : F4
Did that 4-5 times : result is the same.
I did change the swing motor 3 times throughout the life of this finisher.
Each motor lasts about 1.5 -2 mil copies.
Now the finisher is giving a lot of errors :
566-8002
532-8002
540-8002 (have to check on the flag for that)
should I think of a new board or just keep replacing motors...
The result is : F4
Did that 4-5 times : result is the same.
I did change the swing motor 3 times throughout the life of this finisher.
Each motor lasts about 1.5 -2 mil copies.
Now the finisher is giving a lot of errors :
566-8002
532-8002
540-8002 (have to check on the flag for that)
should I think of a new board or just keep replacing motors...
Comment