Finisher Tray B problem (V1)

[tinnyjay]

Hello!
My Canon IR7105 has attached a V1 finisher.
Before 2-3 days tray b never stop from moving up and down.
I removed tray b lastic cover and cleaned 2 sensors but still the same.
Tray can move easily up and down by pressing switch with a screwdriver.
The belt is perfect.
Are you experienced before with this kind of problem ?
Thnx

[teckat]

Re: Finisher Tray B problem (V1)

Hello!
My Canon IR7105 has attached a V1 finisher.
Before 2-3 days tray b never stop from moving up and down.
I removed tray b lastic cover and cleaned 2 sensors but still the same.
Tray can move easily up and down by pressing switch with a screwdriver.
The belt is perfect.
Are you experienced before with this kind of problem ?
Thnx

---------------------------
check ARCNET Connections

so when u power up printer tray b continues to move up & down ?
does it stop at all or error out ?


what is error code ?

it is possible for the connecting pins of the Path Sensor PCB [1] (FM2-4254-
000) to make contact with the Path Guide [2],
Path Guide-------------------check the Path Sensor PCB

If the Error Code E542-8002 or Jam Code 1320 occurs, replace the Path Sensor with the new Photo Sensor
Assembly (FM2-4254-010).

also check the flags
??? did u adjust the sensor intensity

Finisher V1-V2 Adjusting the sensor intensity.pdf

[Rachid.Akli]

Re: Finisher Tray B problem (V1)

Hello!
My Canon IR7105 has attached a V1 finisher.
Before 2-3 days tray b never stop from moving up and down.
I removed tray b lastic cover and cleaned 2 sensors but still the same.
Tray can move easily up and down by pressing switch with a screwdriver.
The belt is perfect.
Are you experienced before with this kind of problem ?
Thnx

Hello,

1- Clean the paper hight sensors UN17 and UN18.

2- Verify the tray motor torque limiters.


Good luck.


Rachid.