Hi.
I have a problem in a iR5075N in the DADF-S1 it produces jams code 0073. Someone could help me? Thanks in advance
I have a problem in a iR5075N in the DADF-S1 it produces jams code 0073. Someone could help me? Thanks in advance
-
-
Re: Jam code 0073 in DADF-S1 on iR5075N
=========================
has a Sensor Init for the document feeder been done in service mode.
0073 jam code from the DADF S1
DADF S1, unit stops and the DADF indicates a jam. Paper is found at the No.1 Registration roller, and exiting the Delivery roller. The jam code listed in service mode is a 0073.
Jam code may be resolved by replacing M4 (separation motor).
This motor executes the pressuring or separation of the Read Roller 1. PI2 (separation HP sensor) detects the rotation and position of the pressure/release lever.
Upon power on, M4 rotates one revolution and ends in a blocked state of PI2. As each sheet is fed through the DADF, M4 will rotate one revolution for each sheet.
If no rotation is detected by PI2, a jam code of 0073 will be generated.
M4 may be operating in an erratic manner due to a weak motor.
M4 can be checked in Service Mode:
Feeder > Function > MTR-CHK-3
M4 part number is: FK2-0207-000**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
Re: Jam code 0073 in DADF-S1 on iR5075N
Many thanks teckat. I'll test that motor next visit and I'll tell you about the result.Comment
-
Re: Jam code 0073 in DADF-S1 on iR5075N
I checked the motor M4 in another DADF and effectively that was the problem. I will replace it with a new one.
Thank you very much teckat.Comment
-
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
Comment