E350-022 appeared (but it has no code like this in the service manual) This machine gives me a lot of headaches lately, I'll post many problems about this machine later.
-
-
Re: E350-022 IRC6800
============
ECO/ID pcb issue
PCB is a controlled item - no part #.
ECO ID PCB can only be obtained by contacting the Canon Technical Support Center.
You may need to contact the TSC hotline!
E350 Faults on ECO ID PCB.
1. Ensure connector J1213 on the Main Controller PCB is connected.
2. Replace ECO ID PCB (Contact Canon TSC Hotline for assistance).
The Counter Memory PCB, ECO ID PCB and SRAM PCB retain information pertinent to the specific engine they are
installed in.
Ensure that you never swap any of these circuit boards with another engine. If any of these circuit boards
are swapped, it can result negatively in equipment performance.
imageRUNNER C3100 / C3100N / C5800 / C6800 / C1022 / C3480 / C5051 / ADV C7000/9000 SeriesDO NOT CHANGE TWO OR MORE BOARDS AT ANY ONE TIME. THIS CAN RESULT IN THE EQUIPMENT ENTERING AN ERROR CODE LOOP. ONCE THIS OCCURS, YOU MUST CONTACT THE CANON TECHNICAL SUPPORT CENTER FOR ASSISTANCE.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
Re: E350-022 IRC6800
Thank you Teckat, you're my hero!Comment
Comment