iR7095/7105 Finisher

[Blues Guy]

Hi guys,

Need you guys advice on these problem. Have 1 unit iR7095 when you 'ON' the machine the machine can't detect the finisher. We have changed the d.c controller finisher a few pcs but still the same.

I wonder is there any setting on the machine to detect it. Any advice guys please...

[jiongpao]

Re: iR7095/7105 Finisher

Hi, you need to activate it at service mode COPIER - OPTION - ACCPST - FINISHER and set it to value 1 (default 0) if it is at ACC1 row.

Finisher activation.jpg

[teckat]

Re: iR7095/7105 Finisher

Also

Check your ARCNET cables for T-Conections and Terminators on the imageRUNNER and the Finisher.

If your display does not show any version, and your ACCPST-D shows the finisher is attached, try the following steps:

1) Set the value listed in the ACCPST-D to "00", press OK

2) Exit service mode, power off the imageRUNNER, and power off the Finisher.

3) Disconnect the ARCNET cable from the imageRUNNER only.

4) Power on ONLY the imageRUNNER.

5) Check COPIER>OPTION>ACCPST-D (At this point the finisher should no longer be listed)



6) Power off the imageRUNNER

7) Confirm BOTH the imageRUNNER and the finisher have T-Connectors and terminators.

8) Power on the finisher, then power on the imageRUNNER (Note: Power on sequence is important.)

9) Check COPIER>OPTION>ACCPST-D The value should be listed as "01" for the finisher. If the ACCPST-D lists the finisher as "00", try setting to "01", then press OK. (Note: If you have other ARCNET devices attached they will be listed, too, assuming you have connected the ARCNET cables with T-Connectors and have terminated the last device.)

10) Check COPIER>DISPLAY>SORTER Now you should see the finisher listed and the finisher functions available.

[teckat]

Re: iR7095/7105 Finisher

Check if the braided ground strap on the finisher has been disconnected when removing the rear cover.
If so>Connecting the ground strap, powering up the finisher and then the host machine, the finisher was again available.

[Blues Guy]

Re: iR7095/7105 Finisher

After try and error for so many days problem solved. The problem was ARCNET cables T-Connector.

Thanks for all the information.

[teckat]

Re: iR7095/7105 Finisher

After try and error for so many days problem solved. The problem was ARCNET cables T-Connector.

Thanks for all the information.

------------------- good find/good luck

"when we walk on fire,we burn feet"


Bad Connection.jpg