IRC 5180 exit faceup/face down

[axslinger]

Canon IRC 5180.....Looking through copier/option/body level 2, I cant find where to change from exiting face down to exiting face up. Can that be changed on this machine?
Thanks for your help.

[teckat]

Re: IRC 5180 exit faceup/face down

Canon IRC 5180.....Looking through copier/option/body level 2, I cant find where to change from exiting face down to exiting face up. Can that be changed on this machine?
Thanks for your help.

-----------------------------
5180-----

The machine only uses any of the following 3 types of delivery (paper paths):

1-face-down delivery only (center delivery tray) UP is NA

2-face-down delivery only (copy tray) UP is NA

3-face-up delivery (side delivery tray) Using no Finisher attached =
If the print jobs come out on the bottom tray, they will print face up
(delivery tray attached to the fixing delivery exit)
*without a finisher attached (just a delivery tray attached to the fixing delivery exit) will output a multi-page document with the page count in reverse order (1,2,3,4,etc...) instead of 4,3,2,1 on face down delivery when delivered via the fixing exit which is usually Tray B.
Then at completion of the job, the user must re-arrange the page order manually.
To correct this >see below

Solution :
In Service Mode Level-2:

COPIER>OPTION>BODY>PRNT-ORD = 1

Factory default = 0

NOTE: This applies to Tray B which is the fixing delivery exit of the side tray with NO FINISHER attached.

PLEASE NOTE THAT THIS SETTING ONLY PERTAINS TO COPY JOBS ONLY!!
paper.JPG

[vigour]

Re: IRC 5180 exit faceup/face down

Never seen anyone use face down copy tray exit.
I always wondered why they had 2 delivery exits.

[teckat]

Re: IRC 5180 exit faceup/face down

Never seen anyone use face down copy tray exit.
I always wondered why they had 2 delivery exits.

Can not use with Finisher Attached/ never had a 5180 that did not have a Finisher

[vigour]

Here is one