irc 2020i

[ernesto]

Hi everybody
I had to replace a black drum in IR ADV C2020i

and it only has 27 k

does anyone Know if this is common in this machines ?

is there a solution ?

drum irc2020i.jpg

many thanks

[bipc]

Re: irc 2020i

unfortunattly that series is known for alot of drum problems from that one to the infamous E020-XXXX errors, for now the solution is to keep changing them

[teckat]

Re: irc 2020i

Hi everybody
I had to replace a black drum in IR ADV C2020i

and it only has 27 k

does anyone Know if this is common in this machines ?

is there a solution ?

[ATTACH=CONFIG]21485[/ATTACH]

many thanks

-----------------------------

all goes by % of toner coverage on documents > & not volume


NOTE==reminder

When installing a new drum or developer assembly you need to run "ITB-Drum" under user setting.
To run the user mode go into setting and registration / adjust maintenance / itb-drum.


There is a user mode that is to be used after replacing the drum units on these machine.
To see the user mode you first must enable it in service mode.
Step one: In service mode change Copier / Option / Display SW / ITB-DSP set to =1
Step two: Go into setting and registration / adjust maintenance / ITB-drum

[shaqmut]

Re: irc 2020i

yes hello!! i used to even on canon ir2018 i found bearing ball of DV get old and drum get same charge and failed very fast but on irc2020i drum their blade are very weak so u have to remove waste toner every 10k

[bipc]

Re: irc 2020i

and of course and like teckat said above the values for duration of toners varies according to percentage of coverage, the value given by canon is when considering a 5% coverage