Help me please ir7095

[freefly]

20130728_192336.jpg

[blazebusiness]

Re: Help me please ir7095

[ATTACH=CONFIG]21588[/ATTACH]

Not much to go on description-wise from you but from the looks of the pic I'm guessing you have a frozen progress bar during bootup.If you are not a tech....now would be the time to call one. You can try reseating DDR-SDRAM) on the main controller PCB. If that doesn't help.....possible hdd failure or main board.

[SCREWTAPE]

Re: Help me please ir7095

[ATTACH=CONFIG]21588[/ATTACH]

The question I have is?
Where you trying something, like upgrading firmware. Or, did this happen upon powering up the machine?

[Simons]

Re: Help me please ir7095

I have a main board and ram for sale

[Canuck]

Re: Help me please ir7095

Pull out transport drawer,open all covers,doors,pull out the process unit(disconnect all connectors).Disconnect finisher and all accessories. Leave front door open and see if it boots. I have seen cleaner blade vibration motors cause dead machine,machine won't boot full properly,all sorts of weird stuff. Clean the contacts on the ram,etc with fine sandpaper and alcohol

[Exok]

Re: Help me please ir7095

This person has clearly been zapped inside the display screen of the machine and is looking for help to escape his imprisonment.

[freefly]

Re: Help me please ir7095

Thanks everyone, it was concluded that the wire is grounded.

[freefly]

Re: Help me please ir7095

But the problem I have left off. I want to program the firmware please send it to me.

[canonbundy]

Re: Help me please ir7095

This person has clearly been zapped inside the display screen of the machine and is looking for help to escape his imprisonment.

Yeah, I saw that & the Firmware is located just underneath the Grounding Wire.......

[Canuck]

Re: Help me please ir7095

This person has clearly been zapped inside the display screen of the machine and is looking for help to escape his imprisonment.

lol