[Error Code] PDL NO RIP Hardware

[gajendragehlot@gmail.com]

Hi,
Can anybody please mention about the Error i am getting on my canon ir5000 machine "e677-5803 PDL No RIP Hardware".

I have gone through previous threads which say to check RIP 1 board, or verify that network printer kit-A1 is installed correctly.

can anybody please mention where should i look for this kit (like give some snapshot of the machine where to look for it"

[SCREWTAPE]

Re: PDL NO RIP Hardware

Main controller...

[gajendragehlot@gmail.com]

Re: PDL NO RIP Hardware

Main controller...

Hey No Snapshut found!!

[SCREWTAPE]

Re: PDL NO RIP Hardware

Hey No Snapshut found!!

Ha, Ha, Ha, Ha

[teckat]

Re: PDL NO RIP Hardware

Hey No Snapshut found!!

E677-5803 PDL No RIP Hardware.

The RIP1 board is not installed or not working properly.

For the imageRUNNER 5000 with the old main controller, check to see if the RIP Board is installed next to the parallel port. If there is not a RIP board installed, then install the Network Printer Kit-A1 (sales item # F61-8502-000). Since the A1 kit has been discontinued...if you get this error and you are installing the Network Printer Kit-A2 in the 5000 (old main controller) then you must replace and install the new main controller. You can only install the Network Printer Kit-A2 in an iR5000 with the new main controller.



Call for a trained service tech