canon ir3300 error

[mramlawi]

dear all
i have the canon ir3300 at my client and as he told me its suddenly gave error e220-0001 ,so i said it lamp or the inverter for it , so i change the lamp and tried same error occur ,also i changed the PCB and also make clear same error is there;s anything must do for this problem ?

[Canuck]

Re: canon ir3300 error

Does the lamp come on? You say you replaced lamp and lamp regulator...new lamp regulator? When you get a replacement lamp for these machines you have to get the new lamp regulator also...

[Canuck]

Re: canon ir3300 error

Read this....

[mramlawi]

Re: canon ir3300 error

thank you for your support ,yea the lamp is blinking when i turn the machine on .

[teckat]

Re: canon ir3300 error

dear all
i have the canon ir3300 at my client and as he told me its suddenly gave error e220-0001 ,so i said it lamp or the inverter for it , so i change the lamp and tried same error occur ,also i changed the PCB and also make clear same error is there;s anything must do for this problem ?

-----------------------------------------------------------------------------------------------------------------
E220-0001
Check and verify the 24V supply to the Reader Controller from the Main Power Supply (Switching Regulator) is present.

It is possible that one of the loads on the DC-Controller can take down the 24 volts.
Remove the 24volt loads off the DC-Controller and connect the connectors one by one to locate the short or defective load.


Unplug the copier and remove the Copyboard glass. Move the scanner manually and check to see if the Scanner Home Position Sensor Flag is coming into contact with the Inverter Pcb, or any of the wiring. Contact with the flag may be causing a short during Scanner movement when copying from the glass.

[mramlawi]

Re: canon ir3300 error

-----------------------------------------------------------------------------------------------------------------
E220-0001
Check and verify the 24V supply to the Reader Controller from the Main Power Supply (Switching Regulator) is present.

It is possible that one of the loads on the DC-Controller can take down the 24 volts.
Remove the 24volt loads off the DC-Controller and connect the connectors one by one to locate the short or defective load.


Unplug the copier and remove the Copyboard glass. Move the scanner manually and check to see if the Scanner Home Position Sensor Flag is coming into contact with the Inverter Pcb, or any of the wiring. Contact with the flag may be causing a short during Scanner movement when copying from the glass.

hello ,
i checked the sensor falg and everything okay
thanks

[Canuck]

Re: canon ir3300 error

The pcb on the new regulator is brown on one side and green on the other. Is this your situation..... New lamp,pcb brown on one side?

[mramlawi]

Re: canon ir3300 error

thanks for all my problem is solved i changed the Power supply Board