[Jamming] Canon ir7095- finisher problem

[rhey_factor_jjrt]

after boot of machine, they indicate in screen, jamming at finisher, when i open the finisher the screen told jamming from A1, even there is no paper inside, can someone help pls. im new one on this machine

[Canuck]

Re: Canon ir7095- finisher problem

Whats the jam code

[rhey_factor_jjrt]

Re: Canon ir7095- finisher jam code

a sample picture of the screen of my machine ir7095,........... help......

[SCREWTAPE]

Re: Canon ir7095- finisher jam code

a sample picture of the screen of my machine ir7095,........... help......

As you open the top portion of the finisher. There is a door on the below right side, sort of speaking. You have to stick in your hand and open the door. Maybe this is your issue. If not, there is a sensor being blocked or its no good.

[canonbundy]

Re: Canon ir7095- finisher jam code

a sample picture of the screen of my machine ir7095,........... help......

These are samples of other Techs findings, hope it helps.

Symptom
Jam history shows jam code 1320 in the finisher.

Cause
It has been found that the inlet sensor PS3 can cause 1320 jam code.

Action
Check the sensor in service mode COPIER > IO > SORTER > PO24 > BIT13 > 1 indicates paper present. Also make sure the entrance guide is not bent. PS3 is a reflector type of sensor. Part number for the sensor (WG8-5736-000).

Symptom Error code E532, E566 and jam code 1320 are occurring alternately. On the Finisher Fuse PCB at connector J413, 24 volts DC is measured at pin 2 to ground and pin 3 to ground. Zero volts would be a normal reading at pin 2 to ground and pin 3 to ground. The Finisher Fuse PCB had been replaced. A resistance measurement of zero ohms at J413, pins 2 and 3 for the Stapler Safety microswitches (MSW5 and MSW6) proved good. Cause In this case, a very high resistance was measured at J414 of the Finisher Fuse PCB for microswitch MSW1 - the Finisher Front Door switch. A zero ohm resistance measurement at J414 is a good reading. Action Replacing MSW1 (FM2-5751-000) resolved the service issue for the finisher. Symptom When the iR is powered on it displays a 1320 jam. Cause The 1320 jam is produced because the saddle stitch controller is missing 24vdc at connector J203. The connection was loose at the rear of the saddle stitch unit. The connector is at the cable holder. The connection is made through cable holder this can be found on Figure Q13 item number 11 in the V1 / V2 parts manual. .. .. .. .. .. ..

..

[rhey_factor_jjrt]

Re: Canon ir7095- finisher problem

thanks for reply.....

[Chedan]

Re: Canon ir7095- finisher problem

Turn of your finisher unit.. then turn it back on.