[Misc] conon

[satish.ambiger]

Hello
I have canon ir3300 and i cleared the machine by below procedure for erorr E007-000
ERR
DC-CON
R-CON
SERVICE
JAM-HIST
ERR-HIST
E354-CLR
E355-CLR
PWD-CLR
ADRS-BK
CNT-MCOM
CNT-DCOM
MMI
CARD
ALARM
is it correct or not for that please suggest. and will it going cause any problems.
Thanks

[Brian8506]

Re: conon

No. You need to replace the fuser film assembly. Did you run a P print? You're gonna have to input the adj and other specs with all that cleared.

[satish.ambiger]

Re: conon

what is mean by p print and specs? and how to run p print and input and adj specs

[teckat]

Re: conon

Hello
I have canon ir3300 and i cleared the machine by below procedure for erorr E007-000
ERR
DC-CON
R-CON
SERVICE
JAM-HIST
ERR-HIST
E354-CLR
E355-CLR
PWD-CLR
ADRS-BK
CNT-MCOM
CNT-DCOM
MMI
CARD
ALARM
is it correct or not for that please suggest. and will it going cause any problems.
Thanks

-------------------------------------------------------------
I hope u did not CLEAR ALL THOSE SETTINGS/ without Printing Out a P PRINT==

Backing Up Service Mode
At the factory, each machine is adjusted, and its adjustment settings are recorded on the
service label (inside the service book case behind the front cover).

If you have cleared the RAM and replaced the PCB, the settings under ADJUST and OPTION
will all return to the factory settings. Be sure to enter the settings indicated on the service
label.
You can/should print out the settings stored in the machine in service mode: before any CLEARING of Anything

COPIER>FUNCTION>MISC-P>P-PRINT. In addition, you can obtain a new service label
using service mode: COPIER>FUNCTION>MISC-P>LBL-PRINT.


Get a Service Manual

u can cause more issues if u don't understand what procedures are needed or used

information purpose only --------------------------------------




E007 (fixing film rotation error)

0000= An error in the rotation of the fixing film is detected.Main cause =The fixing film sensor (PS45) is faulty. / The DC controller PCB is faulty.
Caution = To clear the error, execute the following in service mode:
COPIER>FUNCTION>CLEAR>ERR.

1. Wiring
Are the wring and the connectors connected securely?
DC controller PCB (J311) <-> relay connector <-> fixing film sensor
NO: Connect the wiring and the connectors.

2. Fixing film sensor
Check the fixing film rotation signal.When the fixing motor is rotating, is the film rotation detection signal sent by the fixing film sensor to the
connector J311 of the DC controller PCB?
Film rotation detection signal: 5V pulse signal between J311-A9 (FILM_ROT_D) and J311-A8 (GND); at intervals of 100 msec ON and 440
msec OFF.
NO: If the fixing film is normal, replace the sensor.

3. Fixing film unit, DC controller PCB
Is there a fault in the fixing film edge rotation detection mechanism
YES: Replace the fixing film unit.
NO: Replace the DC controller PCB.