[Error Code] ir-3570 Error code

[wellrajive]

Hey Guys,
this copier is displaying E000355-001 code error ,
when i try to clear it from the service mode it is getting back again .
How can i fix it , please hepl,
thanks

[teckat]

Re: ir-3570 Error code

Hey Guys,
this copier is displaying E000355-001 code error ,
when i try to clear it from the service mode it is getting back again .
How can i fix it , please hepl,
thanks

-----------------------------------------------------------------------------
have u been swapping PCB's

READ ATTACH PDF---

e355
Mismatch of serial numbers of three items: Serial Number PCB, Main Controller/ Image Processor PCB (SRAM) and Counter Memory PCB

E355 code, access Level 3 of Service Mode. This can be done by following the procedures below.
- Press "*", then Press "2" and "8" simultaneously, then Press "*"
- Press " * ", then Press "1" and "9" simultaneously, then Press "3"
- Press Copier / Function / Clear / E355 , then Press OK and then Press Reset
- Turn the machine off, then on using the main switch which is located below and to the rear of the bypass tray.

DO NOT MAKE ANY CHANGES IN LEVEL 3 SERVICE MODE. Only used for the E355 clear.

Any adverse affects on the machine will not be supported by Canon