[Misc] Canon IR7105 Slow Scanning from DADF

[tinnyjay]

Hello!
After i cleaned the platen glass and mirrors,i am getting this message :"Glass is dirty".
The copying from DADF is slower than before.
Can you help me to solve this problem please?
Is there any sensor or what,because platen glass,mirrors and lamp are very clean,but i am stucked.
Thanks


PS: Also white plate on platen glass is so white and cleaned

[Canuck]

Re: Canon IR7105 Slow Scanning from DADF

I'm not near a manual but what happens is when the scan area is too dirty it stops stream reading and goes into a feed-then-scan mode,slowing down its scanning speed. There might be belt wear marks on the glass in the stream read area. Run ccd adjustments,then STRD-POS. Like i said...not near a manual