Canon IR 1025 CQ

[Acme]

Ive got a few of these that after about 20k copies, get really light, almost like a halftone or its set on photo mode but its not. OEM toner is used in all of them, and the only way to get the density back is to put a new developer unit in it.
Any Ideas?

[northernlife]

Re: Canon IR 1025 CQ

Is the coating on the dev extremely light? Are you running a full toner install when you change the dev? If you run a toner stir/install on the old dev does it come back a little bit at all?

[Acme]

Re: Canon IR 1025 CQ

Yes the developer on the mag roller is very thin. I had no idea you had to run a toner stir when adding toner.
Can you give me a heads up on how to run it?
Thanks

[northernlife]

Re: Canon IR 1025 CQ

Swear to god there's a toner stir on this model but I can't find it. you would usually just do it when you replace the dev. Still looking but I could be wrong, wouldn't be the first, nor the last time for that lol.

[teckat]

Re: Canon IR 1025 CQ

Yes the developer on the mag roller is very thin. I had no idea you had to run a toner stir when adding toner.
Can you give me a heads up on how to run it?
Thanks

---------------
no toner stir in this series

how is image on DRUM SURFACE ?
--------------------------------------------------------------------------------------
make sure toner saver is "OFF" in both locations

PRINTER SETTINGS>
PRINT QUALITY>TONER SAVER MODE OFF(*), ON

COMMON SETTINGS>
TONER SAVER MODE OFF(*), ON

-----------------------------------------------------------------------------------
CHECK>Transfer Roller Bias Tab