paper registration IRC 2380i

[vamoursly]

Hello everyone hope you are all fine.

I have an interesting problem with an IRC 2380i. They are saying that text is being shifted higher on a page, A4 or A3. On the bypass using A4 labels the text is not centrally in the label and is dropping off the end of a label;

I have been looking at the service manual for this model and have seen about changing horizontal registration and the margins. Is veritical registration done through service mode, finding the information a little confusing

Thanks

V

[teckat]

Re: paper registration IRC 2380i

Hello everyone hope you are all fine.

I have an interesting problem with an IRC 2380i. They are saying that text is being shifted higher on a page, A4 or A3. On the bypass using A4 labels the text is not centrally in the label and is dropping off the end of a label;

I have been looking at the service manual for this model and have seen about changing horizontal registration and the margins. Is veritical registration done through service mode, finding the information a little confusing

Thanks

V

=========================================

Identifying the Paper Size--BYPASS
=The width of paper is detected with reference to the output of the variable resistor (SVR1), which operates in
conjunction with the movement of the side guide.
The side guide in the manual feed tray is set when the user moves it to place paper in the tray.


Service Modes:

1- Register the reference points
COPIER > FUNCTION > CST > MF-A4R
COPIER > FUNCTION > CST > MF-A6R
COPIER > FUNCTION > CST > MF-A4

Registers basic value of manual feeder's & (DADF's) paper width.
A4R width: 210mm, A6R width: 105mm, A4 width: 297mm
- Once registered, the basic value can be fine-tuned by performing COPIER> ADJUST > CST-ADJ
> MF-A4R, MF-A6R or MF-A4.
Operation method
1) Place A4R size paper in the manual feeder, and set the size guide to the A4R width.
2) In this service mode, select 'MF-A4R' to display the item in reverse.
Press the OK key to perform automatic adjustment and register the value.
3) Repeat Steps 1) and 2) to register the basic values for the A6R and A4 sizes.



2- Adjustment of the foregoing reference points
COPIER > ADJUST > CST-ADJ > MF-A4R
COPIER > ADJUST > CST-ADJ > MF-A6R
COPIER > ADJUST > CST-ADJ > MF-A4

[northernlife]

Re: paper registration IRC 2380i

Service Mode:
COPIER>ADJUST>FEED-ADJ>ADJ-REFE
Use it to adjust the horizontal registration for the 2nd side of small-size double-sided prints.
COPIER>ADJUST>FEED-ADJ>ADJ-RE-L
Use it to adjust the horizontal registration for the 2nd side of large-size double-sided prints.
COPIER>ADJUST>FEED-ADJ>LOOPREFE
Use it to adjust the degree of arching for the 2nd side of double-sided prints.
The term "2nd side of a double-sided print" as used in relation to the machine's service mode refers to the side that receives an image second in order; in other words,
it corresponds to the 1st side of the original.