How do you get into service mode on these new ones. Im trying *28* but no luck. I need to install and calibrate mag developer unit. Thanks
-
-
Re: advance IEC 5045
============
To go to Service Mode Classic Level 1 follow the steps bellow:
1) Select Settings/Registration
2) Hit 2 & 8 at the same time
3) Select Settings/Registration
To go to Service Mode Level 2, go to Service Mode Level 1 and then:
1) Select Settings/Registration.
2) Select 2.
Go to Service Mode follow the steps bellow:
1) Select Settings/Registration
2) Hit 2 & 8 at the same time
3) Select Settings/Registration
4) Select Mode List
5) Select Copier
6) Select Option
7) Select FNC-SW
8) Highlight [Level 1] to toggle between Level 1 and Level 2.
NOTE: For Information Purposes Only
Not responsible
for any actions you take in Service Mode
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
Re: advance IEC 5045
Got it Much appreciated. ThanksComment
Comment