"Waiting........." displayed in a iR 5075.

[Ingranaggio_rotto]

Another Amletico problem ! ! !
(I don't know if "Amletico" is a valid English word) !

When an iR 5075 goes out from stand-by mode (because there's a print queue, or copy), "Waiting......" appears on the screen,
and the machine after about 3 minutes, makes the copy.

During this time I controlled, in the service mode the fixing temperature.
And it's all right.
I have disactivated the potential control... Nothing !
I changed the thermistors (also if all right ), nothing !

Another suggestions ?

[Canon345]

Re: "Waiting........." displayed in a iR 5075.

If this is copy only I would be looking at ADF cont and memory.

[vigour]

Re: "Waiting........." displayed in a iR 5075.

Flaky hard drives sometimes do stuff like that

[teckat]

Re: "Waiting........." displayed in a iR 5075.

Another Amletico problem ! ! !
(I don't know if "Amletico" is a valid English word) !

When an iR 5075 goes out from stand-by mode (because there's a print queue, or copy), "Waiting......" appears on the screen,
and the machine after about 3 minutes, makes the copy.

During this time I controlled, in the service mode the fixing temperature.
And it's all right.
I have disactivated the potential control... Nothing !
I changed the thermistors (also if all right ), nothing !

Another suggestions ?

================================================== =============
check to see if the Fixing temperature is rising. If it is, try disconnecting the Finisher.
If the imageRUNNER will come to ready with the Finisher disconnected there may be a fault in communication with the Finisher, even though no error code is indicated.

Also ..........Check to see if the Staple Cartridge is properly seated.
Check if the Actuator on the bottom of the Staple Cartridge is not making contact with the Micro- Switch in the Staple Unit.
Sometimes, the Actuator may be missing or damaged. If it is missing or damaged the Stapler Cartridge should be replaced.

[Arni]

[teckat]

Re: "Waiting........." displayed in a iR 5075.

================================================== =

also check>clean & re-seat memory and boot rom

[Canon345]

Re: "Waiting........." displayed in a iR 5075.

For sure pull the mem and boot rom and clean those contacts with alcohol. Forgot to mention that. FYI only - When the C5000 machines do this it has been memory/ main cont/ wipe and reload in that order.

[Arni]

Re: "Waiting........." displayed in a iR 5075.

As mentioned above about flanky HD, that was the problem and new one fixed the problem.