[Misc] weird Fiery problem

[Otis252]

I tried to calibrate a Imagepass A1, after getting the calibration sheet and setting on top of the gray scale, closing the doc feeder then hitting done, the doc feed shows a jam. Don't understand why this happens. Never had
this happen before. Any suggests? The mach is an Canon color advance 9075.

Thanks for any advice.

Mark

[teckat]

Re: weird Fiery problem

I tried to calibrate a Imagepass A1, after getting the calibration sheet and setting on top of the gray scale, closing the doc feeder then hitting done, the doc feed shows a jam. Don't understand why this happens. Never had
this happen before. Any suggests? The mach is an Canon color advance 9075.

Thanks for any advice.

Mark

There was a Fiery patch for this Fiery Color Cal false jam issue on the B1.
*******
What happens if u leave up DF COVER, then start calibration_?

[Otis252]

Re: weird Fiery problem

Well, Actually I found an tech pub and there is a patch for the fiery to take care of this problem. Thanks for replying.

[khattab.al.masry]

Re: weird Fiery problem

Just for sharing knowledge here the following website link:
http://fieryforums.efi.com/
which is specialist with fiery problemsI
I hope to be useful for all.

[teckat]

Re: weird Fiery problem

Just for sharing knowledge here the following website link:
http://fieryforums.efi.com/
which is specialist with fiery problemsI
I hope to be useful for all.

=======================================

know about that forum/

dont' see a patch on Canon site for A1 only B1 imagePass

[vigour]

Re: weird Fiery problem

The Patch for A1 is( 1-19MKEX )

[teckat]

Re: weird Fiery problem

The Patch for A1 is( 1-19MKEX )

Thanks, 😎