working on a ir 400s when i go to scan i get the error code E100 i think it has to do with the laser motor but not sure any help would be great thanks
-
-
E100
BD error has occurred.
. The laser unit has a fault.
. The BD PCB has a fault.
. The BD PCB has a fault.
. The laser driver PCB has a fault.
0001 . The BD signal is not
generated during image
formation (2nd sheet pickup
and later).
. The BD signal cycle has
deviated.
0002. The BD signal is not
generated within 2 sec after
the laser has turned on (at
time of 1st sheet pick-up).
Comment