Is there any way to increase the temperature of the fixing unit from the control panel.
is it possible to put a resistor resistor to the THM1-THM3-THM5
can i increase the temp?
i want to increase because
prints are jam at the fixing many times.
it always occurs when the paper has a full photo (too much toner)
if it has low toner like small photos,no problem.
thanks
is it possible to put a resistor resistor to the THM1-THM3-THM5
can i increase the temp?
i want to increase because
prints are jam at the fixing many times.
it always occurs when the paper has a full photo (too much toner)
if it has low toner like small photos,no problem.
thanks
Comment