Canon IR 8070 copier K1N finisher problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • landspeeder
    Trusted Tech

    250+ Posts
    • Feb 2010
    • 355
    #1

    Canon IR 8070 copier K1N finisher problem

    Was working on a IR8070 copier, replaced the laser, and now the copier goes to a suspend mode when trying to print etc. It sounds like its going to print but just suspends itself. If I seperate the finisher, K1N type, and unplug it from the copier, the copier works perfectly. With the finisher plugged in, there is led's lite up on the main board in the back of the finisher, one is blinking, if I open the finisher door the copier detects that its open. When powereing up the copier the finisher doesnt do a startup routine, motor turns, trays move or maybe its not supposed too...I am not sure of that.

    So any one have a idea? Thanks
    You never realize how cheap a professional is until after you let an amateur do it.... and
    if this was an easy thing to do then everybody would be doing it! But it isn't and they are not!!
    Tags: None
    • Brian G
      Technician
      • Mar 2015
      • 21
      #2
      Re: Canon IR 8070 copier K1N finisher problem

      The first thing I would try would be doing a DC-CON CLR and see if it properly boots up after that. After that maybe try reloading the firmware. Are you getting any error codes?

        Comment

        • landspeeder
          Trusted Tech

          250+ Posts
          • Feb 2010
          • 355
          #3
          Re: Canon IR 8070 copier K1N finisher problem

          No error codes at all....just the flashing error light and like I say soon as you unplug the finisher the copier works perfect...can it be a board problem in the finisher and does the finisher have a power up routine when started

          thks

          Originally posted by Brian G
          The first thing I would try would be doing a DC-CON CLR and see if it properly boots up after that. After that maybe try reloading the firmware. Are you getting any error codes?
          You never realize how cheap a professional is until after you let an amateur do it.... and
          if this was an easy thing to do then everybody would be doing it! But it isn't and they are not!!

            Comment

            • Brian G
              Technician
              • Mar 2015
              • 21
              #4
              Re: Canon IR 8070 copier K1N finisher problem

              Yes it could be a finisher controller board problem. Normally when the machine starts up the finisher does "jog" the trays and cycles the rollers.

                Comment

                • landspeeder
                  Trusted Tech

                  250+ Posts
                  • Feb 2010
                  • 355
                  #5
                  Re: Canon IR 8070 copier K1N finisher problem

                  Thanks...I have ordered that board..updates later..oh by the way if it doesnt work we will have to blame you of coarse

                  Originally posted by Brian G
                  Yes it could be a finisher controller board problem. Normally when the machine starts up the finisher does "jog" the trays and cycles the rollers.
                  You never realize how cheap a professional is until after you let an amateur do it.... and
                  if this was an easy thing to do then everybody would be doing it! But it isn't and they are not!!

                    Comment

                    • Brian G
                      Technician
                      • Mar 2015
                      • 21
                      #6
                      Re: Canon IR 8070 copier K1N finisher problem

                      I'm ok with that...wouldn't be the first time I ordered a board and it didn't fix the problem! Thanks to Canon tech support that is!!!

                        Comment

                        Previous template Next
                        Working...