[Misc] finisher f1 f2 of IR5000

[adel_nathan]

Hi every body
I have finisher f1 with copier IR5000
When i make stapple option with 2 paper or more
First paper out and return backe to stand at stopper
But 2nd out and didn't return back ... so it staplle one paper and 2nd one out off position
I chech the paddle soloniod ... it' working good
Also i clean the paddle..but it's not working
Please help

[adel_nathan]

Re: finisher f1 f2 of IR5000

Is there any idea?

[teckat]

Re: finisher f1 f2 of IR5000

Hi every body
I have finisher f1 with copier IR5000
When i make stapple option with 2 paper or more
First paper out and return backe to stand at stopper
But 2nd out and didn't return back ... so it staplle one paper and 2nd one out off position
I chech the paddle soloniod ... it' working good
Also i clean the paddle..but it's not working
Please help

Check the condition of the flapper sensor flag. If the circular flag is worn it can stop the flapper arms at the wrong time and prevent the last page from settling correctly on the stack.

part number for the sensor flag is: FB4-8430-020. A new dowel pin: XD3-2200-122 is also recommended

[adel_nathan]

Re: finisher f1 f2 of IR5000

Thanks alot for your repley
But i search for this part no. And i didn'found it
Please be sure it f1 finisher
If you could but picture of it here
Thanks again

[teckat]

Re: finisher f1 f2 of IR5000

Thanks alot for your repley
But i search for this part no. And i didn'found it
Please be sure it f1 finisher
If you could but picture of it here
Thanks again

------------------


Sorry // miss-read model / not on F1

[adel_nathan]

Re: finisher f1 f2 of IR5000

ok no problem
but what can i do now ???
please help me

[teckat]

Re: finisher f1 f2 of IR5000

ok no problem
but what can i do now ???
please help me

can u post a pic of where issue is happening ?

does this happen when printing or copying