iR 5075

[Apach]

Hi

I have a problem with ir5075n. See a att.

Upper 1/3 of page a have some light area. Print and copy give same result. I'm not sure where is problem. I suspect: Drum, dev or pre-charge corona. Thanks on help.

[teckat]

Re: iR 5075

Hi

I have a problem with ir5075n. See a att.

Upper 1/3 of page a have some light area. Print and copy give same result. I'm not sure where is problem. I suspect: Drum, dev or pre-charge corona. Thanks on help.

Test paper delivery direction ??

rear side ?
front lead edge ?

[Apach]

Re: iR 5075

Direction is from left side. Paper from deck2 A4. Device have 1,5M copies. Last time all coronas and dev is replaced when device meter have cca 1.2M copies. Also drum cleaner is changed before 200k copies. Duplex printing gives same result from both side. Paper is Double A 80g.

[teckat]

Re: iR 5075

Direction is from left side. Paper from deck2 A4. Device have 1,5M copies. Last time all coronas and dev is replaced when device meter have cca 1.2M copies. Also drum cleaner is changed before 200k copies. Duplex printing gives same result from both side. Paper is Double A 80g.

So looking at a portrait document, it's the side edges

[Apach]

Re: iR 5075

So looking at a portrait document, it's the side edges

YesTest.jpg

[teckat]

Re: iR 5075

Yes[ATTACH=CONFIG]29869[/ATTACH]

Same exact both sides \print & copy=Transfer Issue_?

[Apach]

Re: iR 5075

Same exact both sides \print & copy=Transfer Issue_?

Yes

[wassem]

Re: iR 5075

the laser unit and the dust proof filter should be cleaned

[mramlawi]

Re: iR 5075

U need to adjust the primary corona wire screwdriver always this happen with me also you can go to servicd mode function develop raise the decrease the value from 180 to 135 and the next one put it -20 and check the copy if any changes happen .

[vigour]

Re: iR 5075

Just rewire your coronas. copier 101

[teckat]

Re: iR 5075

Just rewire your coronas. copier 101

Tip to Apach👀
Make sure your hands\fingers are "Oil Free" on corona wire replacement.