[Error Code] IR Adv 5250 E075-0103

[godyng]

I had a iR Adv 5250 display this error code and i already change a new ITB unit Before
Afther used 90000 this code is indicate again
I check this ITB is with the improvement kid
Now i adjust the itb up/down motor position run the ITB-INIT 3 times , the result is arround -100 and become normal
Please tell me what can i do now is better , many thanks !!

[teckat]

Re: IR Adv 5250 E075-0103

I had a iR Adv 5250 display this error code and i already change a new ITB unit Before
Afther used 90000 this code is indicate again
I check this ITB is with the improvement kid
Now i adjust the itb up/down motor position run the ITB-INIT 3 times , the result is arround -100 and become normal
Please tell me what can i do now is better , many thanks !!

=======================Try Replacing the Drum Driver PCB and perform an ITB-INIT for the E075-0103 error code.
The part number for UN4 Drum Driver PCB is FM3-7934-000.




The Drum Driver PCB controls the ITB Displacement motor & ITB motor.




also re-check that Transfer Arm for any cracks (FC0-5024-010 NEW TYPE)
T ARM.jpg

Being different from imageRUNNER ADVANCE C5000 series, the imageRUNNER ADVANCE C5200 series is not subject to a sloping floor. Therefore the adjustment of the ITB-POS value may not be adequate even after adjusting the height of the caster. The imageRUNNER ADVANCE C5200 series possesses a mechanism to adjust the equilibrium position inside the ITB unit.

[amraklve]

Re: IR Adv 5250 E075-0103

There is a technical document that advises about unlevel floors causing the e075 error. Adjust the floor leveling castors for optimal results

Sent from my SM-G900I using Tapatalk