Hello there!
I'm battling with a 9600 which misaligns the prints, mostly at the beginning (but also during the remainder of the printout).
If I make the bidirectional adjustments, the problem goes away but then comes back - all it takes is, according to the customer, to turn off and on the machine.
Cleaned the carriage encoder strip, but made no difference whatsoever.
Here are a couple of shots of an example:
exemplo2.jpgexemplo1.jpg
Should I consider an NVRAM replacement (since it looks like the machine is losing the adjustments)? Or could there be something else at work here?
I'm battling with a 9600 which misaligns the prints, mostly at the beginning (but also during the remainder of the printout).
If I make the bidirectional adjustments, the problem goes away but then comes back - all it takes is, according to the customer, to turn off and on the machine.
Cleaned the carriage encoder strip, but made no difference whatsoever.
Here are a couple of shots of an example:
exemplo2.jpgexemplo1.jpg
Should I consider an NVRAM replacement (since it looks like the machine is losing the adjustments)? Or could there be something else at work here?
Comment