KM223 Developer Unit.... or is it ?

[agudmove]

KM223 Developer Unit.jpg

I was sent this KM223 dev unit from our stores, I don't know what machine it is for but it isn't for a KM223.

The box has the correct part no., there isn't a connector front right of the unit, and the protruding part you see at the rear is a filter.
Has anyone seen this unit before.

[CraigW]

Re: KM223 Developer Unit.... or is it ?

The connector is there, it is clipped up underneath. And that plenum will go right it the opening in the machine. Yes, vastly different part #.

[allan]

Re: KM223 Developer Unit.... or is it ?

That toner filter piece was a later addition. I don't think the 282 machines had those?

[rrrohan]

Re: KM223 Developer Unit.... or is it ?

That toner filter piece was a later addition. I don't think the 282 machines had those?

He said 283 not 282.

Sent from my SM-G900I using Tapatalk

[allan]

Re: KM223 Developer Unit.... or is it ?

Ok

[allan]

Re: KM223 Developer Unit.... or is it ?

[ATTACH=CONFIG]30437[/ATTACH]

I was sent this KM223 dev unit from our stores, I don't know what machine it is for but it isn't for a KM223.

The box has the correct part no., there isn't a connector front right of the unit, and the protruding part you see at the rear is a filter.
Has anyone seen this unit before.

Figured it out yet?
If the TD sensor is missing there would be no connector.
And if there is no block connector on the back its not for the older machines.

[agudmove]

Re: KM223 Developer Unit.... or is it ?

No, sent the part back, I'll figure it out next time.

[rrrohan]

Re: KM223 Developer Unit.... or is it ?

No, sent the part back, I'll figure it out next time.

Jee didn't try very hard.

Sent from my SM-G900I using Tapatalk

[CraigW]

Re: KM223 Developer Unit.... or is it ?

I just recently put one of those into a 36.

Threw me at 1st with the all new part # and all.